<menu id="myki2"></menu>
<nav id="myki2"></nav>
  • <nav id="myki2"></nav>
    <nav id="myki2"><optgroup id="myki2"></optgroup></nav>
  • 網站公告:

    新聞中心

    濟南精拓流體設備有限公司

    電話:0531-69951198

    郵箱:jingtuolt@163.com

    傳真:0531-69951198

    地址:濟南市歷城區西周南路9號

    網址:http://www.massonisweb.com

    網站公告

    當前位置:首頁 - 網站公告 - 挑選自來水增壓泵需要選擇

    挑選自來水增壓泵需要選擇什么?

    發布時間:2019-06-14 16:11:01   發布人:http://www.massonisweb.com
    1、 有些緣由的水壓低,不用定用增壓泵:
    1. For some reasons, the water pressure is low and the booster pump is not required.
    構成水壓問題的緣由有許多,假設是像老房用水箱水壓力缺乏等緣由,可以經過設備增壓泵來處置。而比如管道老化梗塞、90度彎頭過多等也會構成水量減小,但這些緣由構成的水壓低,增壓泵的改良作用就很有限了。另外,假設設備了處置量較小的凈水器,用水量過大也會呈現水流質變小,有些用戶就想當然地方案裝個增壓泵,當然也是沒有作用的。
    There are many reasons for the formation of water pressure problems, such as the lack of water pressure in the water tank of the old house, which can be disposed of by a booster pump. For example, pipeline aging infarction, excessive 90 degree elbows and so on will also constitute a decrease in water volume, but these reasons constitute a low water pressure, booster pump improvement is limited. In addition, assuming that the equipment has a smaller disposal capacity of water purifier, excessive water consumption will also show a smaller water quality, some users take it for granted that the local plan to install a booster pump, of course, is also ineffective.
    2、根據詳細狀況來選類型:
    2. Choose the type according to the details:
    增壓泵有個特征,當管道水量跟不上水泵流量或者超越水泵流量時,增壓作用會不明顯。所以選購增壓泵要根據詳細狀況來決議類型,比如承壓式電熱水器由于其設備特別,就需求流量較大的水泵,否則難以起到作用。
    Supercharging pump has a characteristic, when the pipeline water can not keep up with the pump flow or exceed the pump flow, the effect of supercharging will not be obvious. Therefore, the choice of supercharged pumps should be based on the detailed situation to determine the type, such as the confined electric water heater because of its special equipment, the demand for larger flow pumps, otherwise it is difficult to play a role.
    水泵的主要參數有功率、揚程、流量等。水泵商場良莠不齊魚龍混雜,許多廠商為了迎合顧客追求高參數的心理,在標注參數時常常注入許多水分。還有那些熱水增壓泵,也有無良商家直接把常溫的硬說成熱水的。這樣的水泵買回家長期在熱水環境下運用,輕則縮短運用壽命,重則惹起電線短路招致火災。
    氣體增壓泵
    The main parameters of the pump are power, head, flow, etc. In order to cater to customers'psychology of pursuing high parameters, many manufacturers often inject a lot of water into marking parameters. There are also those hot water booster pumps, there are no good business directly to the room temperature as hot water. Such pumps have been used in hot water environment for a long time, which can shorten the service life of pumps, and cause short circuit of power lines and fire.
    假設條件允許的話,倡議用戶在購置的時分應該盡量選擇比擬好的牌子,同時用戶也必定要向商家詳細理解家用自來水增壓泵的理論參數,然后根據本人的理論出產需求來選擇。假設依然擔憂商家不照實奉告,還有個小訣竅,就是看體積和重量。普通狀況下,體積小、重量輕的水泵理論參數不會比擬大較重的水泵高。
    Assuming that conditions permit, users should try their best to choose a comparable brand when purchasing. At the same time, users must understand the theoretical parameters of household tap water booster pump in detail to the merchants, and then choose according to their theoretical production demand. Assuming that businesses are still worried about not telling the truth, there's another trick: look at volume and weight. Under normal conditions, the theoretical parameters of small size and light weight pumps are not higher than those of large and heavy pumps.
    自來水增壓泵作業原理相似于壓力增壓器,對大徑空氣驅動活塞施加一個很低的壓力,當此壓力作用于一個小面積活塞上時,發作一個高壓。
    The working principle of the tap water booster pump is similar to that of the pressure booster, which exerts a very low pressure on the large diameter air-driven piston. When this pressure acts on a small area piston, a high pressure occurs.
    經過一個二位五通氣控換向閥,增壓泵可以完成接連運轉。由單向閥操控的高壓柱塞不時的將液體排出,增壓泵的出口壓力大小與空氣驅動壓力有關。當驅動局部和輸出液體局部之間的壓力抵達均衡時,增壓泵會中止運轉,不再消耗空氣。當輸出壓力降落或空氣驅動壓力增加時,增壓泵會主動發起運轉,直到再次抵達壓力均衡后主動中止。
    Through a two-position five-ventilation controlled reversing valve, the booster pump can complete continuous operation. The high-pressure plunger controlled by one-way valve discharges liquid from time to time. The outlet pressure of the booster pump is related to the air driving pressure. When the pressure between the driving part and the output part reaches equilibrium, the booster pump will stop running and no longer consume air. When the output pressure drops or the air-driven pressure increases, the booster pump will actively start operation until it reaches the pressure equilibrium again.
    感謝您的閱讀與觀看,本文的精彩內容來自:氣體增壓泵我們會有更多的精彩內容繼續為您呈現,詳情請點擊:http://www.massonisweb.com
    Thank you for your reading and watching. The wonderful content of this article comes from: Gas Booster Pump, we will have more wonderful content to continue to show you. For more details, please click: http://www.massonisweb.com.

    13188935873

    qq

    甘肃11选5